Table of Contents
Advertisement
CIP5000 series storage
Figure 5.3: Placing the enclosure hardware onto the rack rails
Figure 5.4: Secure to rack
Figure 5.5: System installed in rack
To install the enclosure hardware into a rack with the supplied rails:
1.
2.
Bosch Security Systems B.V.
Brackets
Rails installed
and tightened
Screws and flange
nuts attach the
enclosure hardware
to the rack posts
Vertical rack post
Handles mount
outside the rack post
Check the fit of the rails in your rack system.
Adjust the length of the rails as needed.
–
The rear half of the rail slides inside the front half. The rail halves are riveted
together, so no adjustment screws are needed.
–
The front-left and front-right rail ends are labeled.
–
Be sure the front rail support is on the bottom facing inward.
–
All rail ends, front and rear, attach at the outside of the rack posts.
–
The guide pins at the rail ends align with the holes in the rack posts.
3U 16-bay
enclosure hardware
Mounting rails mount
outside the rack post
User manual
Hardware configuration | en
2019-10 | V01 | F.01U.380.030
21
Advertisement
Table of Contents
