Section 3
Notes
B649
B649
Complex programming example
16.
Confirm your inputs by pressing the VSK 8 "OK".
The following three program blocks are inserted into
the work plan window.
17.
Program the program end and simulate the meas-
urement of the work piece.
Place the orange selection on the program block
"End of program" and extend the line by pressing the
blue "cursor-to-the-right" key on the keyboard.
18.
The input mask for the program end opens.
Here, you can decide to repeat the program run.
Accept the default value and press the VSK 8
"Accept".
Switch back to the horizontal softkey bar 1 by press-
ing the „Extend"-key on the operator panel.
The horizontal softkey bar 1 opens.
.
Press the HSK 1.7 "Simulation" to start the simula-
tion of the measurement.
The control calculates the simulation and opens the
simulation window in "Side view" by default.
Page 14
840D/828D SINUMERIK Operate