Smc40 Sensor Module Cabinet (Only For Direct Measuring Systems) - Siemens Sinamics S120 Comissioning Manual

Diagnostics
5.2 Diagnostics using LEDs
LED Color Status
Green/ Flashing
orange light
or
Red/
orange
OUT > 5 – Off
V
Orange Continuous
light
The parameters for activating component recognition using LEDs can be taken from the following reference:
1)
Reference: /LH1/ SINAMICS S120/S150 List Manual
5.2.3.4

SMC40 Sensor Module Cabinet (only for direct measuring systems)

Table 5- 14 Meaning of the LEDs on the Sensor Module Cabinet-Mounted SMC40
LED Color Status
RDY – Off
READY
Green Continuous
light
Orange Continuous
light
Red Continuous
light
Green/ Flashing
red light
2 Hz
Green/ Flashing
orange light
or
Red/
orange
The parameter for activating component recognition can be taken from the following reference:
1)
Reference: /LH1/ SINAMICS S120/S150 List Manual
Each channel has a multifunction LED.
148
Description, cause
Component recognition via LED is activated
Note:
Both options depend on the LED status when component
recognition is activated.
The electronic power supply is missing or outside permissi-
ble tolerance range.
Power supply ≤ 5 V.
The electronics power supply for the encoder system is
available.
Power supply > 5 V
Description, cause
The electronics power supply is missing or outside the per-
missible tolerance range.
The component is ready for operation. Cyclic DRIVE-CLiQ
communication is taking place.
DRIVE-CLiQ communication is being established.
This component has at least one fault.
Note:
LED is controlled irrespective of the corresponding messag-
es being reconfigured.
Firmware download is complete. The system waits for
POWER ON.
Component recognition via LED is activated
Note:
Both options depend on the LED status when component
recognition is activated.
.
1)
.
1)
Commissioning Manual, (IH3), 07/2016, 6SL3097-4AA10-0BP0
Remedy
–
–
–
Remedy
–
–
–
Remove and
acknowledge the fault.
Carry out a POWER
ON.
–
Commissioning with Startdrive