Siemens Sinamics S120 Comissioning Manual page 112

Commissioning
4.6 Basic parameterization of the drive objects
To enable a user and activate a password, proceed as follows:
1. Activate option "Enable SINAMICS user" or "Enable administrator user".
You can also activate both users.
2. Click on "Specify password".
The "Set password" dialog box opens.
Figure 4-47
3. Enter the new password (max. 10 characters) in the "New password" field. Pay attention
to upper and lower case.
4. Repeat the password in the "Confirm password" field.
For security reasons, the password entries displayed in the input fields are encrypted.
5. Click "OK" to confirm the input in the password dialog.
If both password entries were identical, the input dialog box is closed. If both entries do
not match, the input dialog box remains open and an error message is displayed. At the
same time, the two entries in the input dialog are cleared. In this case, you must enter the
password again in the two input fields.
The password is queried once when the corresponding web page is subsequently called.
6. Then save the project to accept the settings.
112
Setting the password
Commissioning Manual, (IH3), 07/2016, 6SL3097-4AA10-0BP0
Commissioning with Startdrive