Commissioning - Huawei ECC500 User Manual

ECC500 (Data Center)
User Manual
Figure 4-6 Connection between the ECC500 and the IP network

4.4 Commissioning

After installing the ECC500, verify the connection of all cables, power on the ECC500, check
the status of all indicators, and set communication parameters for the ECC500 on the LUI.
Checking Cable Connection and Powering on the ECC500
Power on the ECC500 after verifying that the DC power cable, communication cable, and
signal cable are properly connected to the main control module and basic I/O module.
Checking Indicator Status
Verify the indicator status for the main control module and basic I/O module.
the ECC500 indicators in normal state.
Table 4-2 ECC500 indicators in normal state
Module
Main control
module
Basic I/O module
Issue 06 (2020-01-06)
Normal State
 The operation indicator keeps blinking (1s on and 1s off).
 The alarm indicator is always off.
 The power indicator is always on.
 The operation indicator keeps blinking (1s on and 1s off).
 The alarm indicator is always off.
Copyright © Huawei Technologies Co., Ltd.
4 Installation and Commissioning
Table 4-2 lists
26