Bppx Processor Leds; Flash Codes For Bppb-Based Mark Vies I/O Packs - GE Mark VIeS System Manual

11.1.3 BPPx Processor LEDs

PWR
J4
ATTN
LINK
TxRx J3
Link
TxRx
Processor LEDs
Flash Codes for All Mark VIe I/O Packs and BPPC-based Mark VIeS I/O Packs
Flashing Pattern
LED
Solid
4 Hz 50%
2 Hz 50%
Red ATTN 1 Hz 50%
0.5 Hz 50%
LED out
Two 4 Hz pulses every 4 sec
Solid
Green ATTN
2 Hz 50%
1 Hz 50%
Two 4 Hz pulses every 4 sec
LED Flashing Pattern
LED out
LED solid on
Red ATTN
4 Hz 50%
1.5 Hz 50%
0.5 Hz 50%
Two 4 Hz pulses every 4 sec
442 GEH-6855_Vol_II
Description
Color Label
Displays the presence of control power
Green PWR
Provided for each Ethernet port to indicate if a valid Ethernet connection is
Green LINK
present
Provided for each Ethernet port to indicate when the I/O module is
Yellow TxRx
transmitting or receiving data over the port
Red and
Displays I/O module status
ATTN
Green
Booting - prior to reading board ID
Diagnostic alarm active
Awaiting an IP address
No firmware to load (Program mode)
Application code not loaded to the I/O module
Initializing, no problems detected
Application online
BIOS (at power on), but if it remains in this state, the I/O module is not functioning
properly and should be replaced
Awaiting Auto-Reconfiguration release
I/O module in WAIT or STANDBY
Application online

Flash Codes for BPPB-based Mark VIeS I/O Packs

Description
There are no detectable problems with the I/O pack.
A critical fault is present that prevents the I/O pack from operating.
There could be hardware failures on the processor or acquisition
boards, or there is not any application code loaded.
An alarm condition is present in the I/O pack. These alarms include:
wrong I/O pack/terminal board combination, terminal board is missing,
or errors in loading the application code.
The I/O pack is not online.
This is used during factory testing.
Application online
GEH-6855_Vol_II Mark VIeS Functional Safety Systems Volume II
Description
Public Information