Tool management
5.1
Introduction
For the magazine and PLC configuration, you must create the commissioning file yourself,
which is then executed once by the NCK.
The commissioning file is a part program e.g. _N_MAGKONF_MPF.
Two program examples are provided in the toolbox CD, which you can use as template.
Note
Graphic support for commissioning is not available for tool management with HMI-
Embedded.
HMI-Embedded supports up to 4 real tool magazines.
Creating a commissioning file
There are several ways to create the part program:
● Enter at the operator panel (OP 030) of HMI-Embedded.
● Enter at an external PC, using an ASCII editor without formatting.
● Load the example from the toolbox CD and modify at HMI-Embedded or at the PC.
● Create using HMI-Advanced commissioning tool and load into the NCK.
Commissioning HMI-Embedded (IM2)
Commissioning Manual, 01/2008, 6FC5397-8CP10-1BA0
5
87