In the "Program" and "Services" operating areas, the first four softkeys of the established
connections are displayed in the horizontal bar. The other four softkeys appear in the second
horizontal bar, which can be viewed by pressing the ">" ETC key.
The selection of the drive can be prevented by setting the appropriate access level.
2.3.2
Configuring the network
Settings
The data required for networking the components are entered in the "Network Configuration"
window.
Only the TCP/IP protocol is supported and can be configured within the network setup
screens.
1. In the "Startup" operating area press the "Network Config." softkey. The following window
appears:
Figure 2-2
Commissioning HMI-Embedded (IM2)
Commissioning Manual, 01/2008, 6FC5397-8CP10-1BA0
Configuring the network
Configuring the HMI system
2.3 Setting-up network connections
17