VSB 40.1
6
Display and Operating Components
6.1
Power Button
6.2
Display, Monitor and Keyboard
Display VDP
VGA Monitor
Selection of the Graphic Driver
DOK-SUPPL*-VSB*40.1***-PR01-EN-P
Besides the connector panel (see Fig. 7-1) a button labeled with "PWR" is
provided.
Usually, this power button has no function, as the VSB 40.1 is started by
applying the supply voltage. This is preset in BIOS. If, for example, this
BIOS setting has been changed by mistake, the VSB 40.1 can be started
by activating this button.
To reset the original status, in which the VSB 40.1 also starts without
pressing the power button immediately after applying the supply voltage,
activate the BIOS setup during the booting process with the <Entf> or
<DEL> key. There, activate menu "Power Management Setup". Select in
this
menu
under
item
"[Former-Sts]".
To display and operate the VSB 40.1 we recommend the displays
VDP 16, VDP 40 and VDP 60 especially designed by Bosch Rexroth for
industrial applications. The displays are connected with the VSB 40.1 via
the GIGASTAR interface. Hence, you can install the display up to 30
meters away from the PC. The VDP-type displays are equipped either
with a keypad or with a touch screen.
Note:
Detailed information you will find in the corresponding
documentation.
You can also connect mouse and keyboard to this displays.
You can connect a standard monitor (female connector XVGA), a PS2
keyboard (female connector XKB) and a PS2 mouse (female connector
XMS) with the VSB 40.1.
Note:
If a VDP is used, keyboard and mouse may only be connected
to this display. The keyboard and mouse interfaces at the
VSB 40.1 are then inactive.
When the VSB is delivered, the settings allow to trigger both a connected
monitor and a connected VDP.
Display and Operating Components
"PWRON
After
PWR-Fail"
6-1
the
setting