Fig. 8-10: Loosen The Fastening Screws Of The Hard Disk - Bosch Rexroth VSB 40.1 Project Planning Manual

8-8
Maintenance and Installation
9. Loosen the screws, with which the hard disk is mounted, with a
Philips screwdriver by inserting it through the holes in the mounting
frame.
Fig. 8-10: Loosen the fastening screws of the hard disk
10. Remove the old and insert the new hard disk.
11. Plug-in the cables at the hard disk and, if necessary, at the CD/DVD
drive. Observe that you don't bend the connection pins.
Note: Check the cable connections leading to the hard disk for
tightness.
12. After having plugged-in the cables, put the VSB 40.1 in the mounting
plate (mounting frame). Observe not to squeeze any cables.
13. Connect the mounting plate (mounting frame) and VSB 40.1 with the
four screws.
14. The new hard disk parameters are automatically recognized by the
system. If the operating system does not boot automatically after
switching on the VSP, interrupt the power supply for at least 10
seconds and restart.
15. After properly booting the PC the user data and the operating system
settings for the normal operating mode have to be restored.
VSB 40.1
83_LS_Schrauber.JPG
DOK-SUPPL*-VSB*40.1***-PR01-EN-P