Gigastar Interface X71 - Bosch Rexroth VSB 40.1 Project Planning Manual

7-8
PC Box

GIGASTAR interface X71

X71 – GIGASTAR Interface
Note: The connected mouse must be PS/2-compatible. Normally,
the BIOS reserves IRQ 12 for the PS/2 mouse. If there are
address conflicts, e. g., if IRQ 12 has already been used by
another PC extension card, you should change the IRQ of this
extension card to another IRQ, that is still not-assigned.
Note: If a VDP display is used, the mouse may only be connected to
this display. The mouse interface XMS at the VSB 40.1 is then
inactive.
The GIGASTAR interface is assigned to the 25-pin D-Sub female
connector X71. To this female connector you connect via a ready-made
cable available as accessory (see page 10-2) a display VDP 16, VDP 40
or VDP 60.
Note: When the VSB is delivered, the settings allow to trigger both a
connected monitor and a connected VDP.
How to change this selection, if required, is described in
section "Selection of the Graphic Driver" on page 6-1.
VSB 40.1
DOK-SUPPL*-VSB*40.1***-PR01-EN-P