Pod; Hdmi Capture Box - Sony Vision Exchange PEQ-C100 System Integration & Services Manual

Note
If [Tablet PC Settings] is not displayed, check the USB cable connection of the touch panel
display, then do step 4 again.
5. Click [Setup] on the [Display] tab of the [Tablet PC Settings] window.
6. Follow the on-screen instructions to configure the main display and second display touch
panel assignments.
7. Click [Calibrate] on the [Display] tab of the [Tablet PC Settings] window.
8. Follow the on-screen instructions to adjust the touch panel range for the main display and
second display.
Third-party device driver installation
Device drivers must be installed separately for touch panel displays and other devices whose
connection is not recognized by the Windows standard driver.
For details, see "Third-party device drivers and applications" (page 65) in the "Installing
Third-Party Software" section.

Pod

Connect between the main unit and Pods using wired LAN network connections.
Note
Enable only one Ethernet setting in [Network Connections] in the [Control Panel]. Disable
Wi-Fi, Bluetooth, and other networks.
For details about the computer setup procedure, refer to the manual supplied with the
computer.
For details about operation of Pod PC Software, refer to the Help Guide.

HDMI capture box

Use the following procedure on a Pod on which Pod PC Software has been activated.
1. Connect the USB 3.0 cable supplied with the HDMI capture box between the HDMI capture
box and the USB 3.0 port on the Pod.
2. Connect the HDMI cable between the HDMI input connector on the HDMI capture box and
the the HDMI output device.
3. Turn on the Pod.
The HDMI input function becomes enabled.
The HDMI cable can be disconnected and reconnected during Pod operation.
69