Selection And Start Of Part Program Or Part Program Block - Siemens SINUMERIK 840D sl Function Manual

200: Name/symbol is known, but interpretation is not possible
2xx: Name/symbol is known, the command can be programmed, if xx > 0
Definition for name/symbol:
Name: Any STRING that is checked to see
whether it is a component of the NC language in the existing NCK version or configuration.
Symbol: Contains the description or significance of an NC language command that is needed
for the NC program and cycle interpretation.
Dependent on machine data MD10711
$MN_NC_LANGUAGE_CONFIGURATION = (set value) results in the following interpretations of
the option and function relative to their programmability 2xx:
Table 9-2
MD10711 =
Option
0
1
1
0
Definition for option/function:
0 corresponds to option not activated or function deactivated
1 corresponds to option activated or function activated
For more detailed information on the value ranges of 2xx programmable functions, see:
References:
Programming Manual, Job Planning, Additional Functions,
Section: Check scope of NC language present (STRINGIS)
9.9.2

Selection and start of part program or part program block

Reset status
Channel status
A part program can be selected only if the relevant channel is in the Reset state.
Start command, channel status
There are two possible START commands for initiating processing of a part program or part
program block:
● The channel-specific interface DB21, ... DBX7.1 (NC Start), which is usually controlled from
the machine control panel key NC Start, starts program execution in the same channel.
● With the NC instruction START, program execution in the first channel can be started from
the second channel, for example.
Basic Functions
Function Manual, 01/2015, 6FC5397-0BP40-5BA2
K1: Mode group, channel, program operation, reset response
Setting options
0
Function Return value as the basic information (1st digit from the left)
0 2
0 2
1 2
1 2
1 2
1 0
2 2
2 2
1 0
9.9 Program operation
3 4
1 0
1 0
2 2
1 0
529