ABB IRC5 Operating Manual page 104

5 Troubleshooting by event log
5.3 1 xxxx
Continued
10146, Task selection panel is cleared
Description
Task arg has been removed in Task Selection Panel by arg.
Recommended actions
10147, Setting of variable
Description
Variable arg has changed to value arg by arg.
Recommended actions
10148, Setting of IO
Description
IO signal arg has changed value to arg by arg.
Recommended actions
10149, Program Pointer moved to routine
Description
The program pointer in task arg has been moved to routine arg
by arg.
Recommended actions
10150, Program started
Description
Execution of task arg has been started from the first instruction
of the task's entry routine. The originator could not be
determined.
Recommended actions
10151, Program started
Description
Execution of task arg has been started from the first instruction
of the task's entry routine. The originator is an external client.
Recommended actions
10152, Program started
Description
Execution of task arg has been started from the first instruction
of the task's entry routine. The start order was initiated by an
action causing the UNDO handler to execute.
Continues on next page
104
10153, Run mode is changed
Description
Run mode has been changed to single cycle by arg.
10154, Run mode is changed
Description
Run mode has been changed to continuous mode by arg.
10155, Program restarted
Description
Execution of task arg has been restarted from where it was
previously stopped. The originator could not be determined.
Recommended actions
10156, Program restarted
Description
Execution of task arg has been restarted from where it was
previously stopped. The originator is an external client.
Recommended actions
10157, Program restarted
Description
Execution of task arg has been restarted from where it was
previously stopped. The restart order was initiated by an action
causing the UNDO handler to execute.
10158, Program started
Description
Stepwise forward execution of task arg has been started.
10159, Program started
Description
Stepwise backward execution of task arg has been started.
10160, Pulsing of IO
Description
IO signal arg has been pulsed by arg.
Recommended actions
10170, Background task arg
Description
refuse to start. Task is empty.
© Copyright 2005-2018 ABB. All rights reserved.
Operating manual - Troubleshooting IRC5
3HAC020738-001 Revision: AA