FD 100/320Gbps NT and FX NT IHub Services Guide
7.10.4
7.10.4.1
Table 454
7.10.4.2
Table 455
Issue: 13
VPRN Interface DHCP Commands
dhcp
dhcp command
Item
Description
Syntax
dhcp
Context
configure>service>vprn>interface
Description
This command enables the context to configure DHCP parameters.
gi-address
gi-address command
Item
Description
Syntax
gi-address ip-address [src-ip-addr]
no gi-address
Context
configure>service>vprn>interface>dhcp
Description
This command configures the gateway interface address for the DHCP relay. The GI address
is needed, when the router functions as a DHCP relay, to distinguish between different
interfaces.
By default, the GI address used in the relayed DHCP packet is the primary IP address of the
interface on which the DHCP boot requests are relayed. Any primary or any secondary address
of an interface of the concerned router instance can also be specified.
Default
No gi-address
Parameters
ip-address — Specifies the host IP address to be used for DHCP relay packets.
src-ip-address — Specifies that this GI address is to be the source IP address for DHCP relay
packets.
3HH-11985-AAAA-TQZZA
Virtual Private Routed Network Service
477