Table 153 Vlan-Vc-Tag Command; Vlan-Vc-Tag - Nokia 7302 Manual

Virtual Private LAN Service
(2 of 2)
5.16.2.29
Table 153
268
Item Description
Description This command specifies the precedence of the SDP binding when there are multiple SDP
bindings attached to one service endpoint. The value of zero can only be assigned to one SDP
bind making it the primary SDP bind. When an SDP binding goes down, the next highest
precedence SDP binding will begin to forward traffic.
The no form of the command returns the precedence value to the default.
Default 4
Parameters precedence-value — Specifies the spoke SDP precedence.
Values 1 — 4
primary — Specifies to make this the primary spoke SDP.

vlan-vc-tag

vlan-vc-tag command
Item Description
Syntax vlan-vc-tag 0..4094
no vlan-vc-tag 0..4094
Context configure>service>vpls>spoke-sdp
configure>service>vpls>mesh-sdp
configure>service>pw-template
Description This command specifies an explicit dot1q value used when encapsulating to the SDP far end.
When signaling is enabled between the near and far end, the configured dot1q tag can be
overridden by a received TLV specifying the dot1q value expected by the far end. This signaled
value must be stored as the remote signaled dot1q value for the binding. The provisioned local
dot1q tag must be stored as the administrative dot1q value for the binding.
When the dot1q tag is not defined, the default value of zero is stored as the administrative
dot1q value. Setting the value to zero is equivalent to not specifying the value.
The no form of this command disables the command
Default No vlan-vc-tag
Parameters 0..4094 — Specifies a valid VLAN identifier to bind an 802.1Q VLAN tag ID.
3HH-11985-AAAA-TQZZA
FD 100/320Gbps NT and FX NT IHub Services Guide
Issue: 13