Table 170 Ve-Id Command; Table 171 Shutdown Command; Ve-Id - Nokia 7302 Manual

FD 100/320Gbps NT and FX NT IHub Services Guide
(2 of 2)
5.16.2.45
Table 170
5.16.2.46
Table 171
(1 of 2)
Issue: 13
Item Description
Description This command creates or edits a ve-name. Just one ve-name can be created per BGP VPLS
instance.
The no form of this command removes the configured ve-name from the bgp vpls node. It can
only be used when the BGP VPLS status is shutdown. Command "no shutdown" cannot be
used if there is no ve-name configured.
Default no ve-name
Parameters name — A character string identifying the VPLS Edge instance.
Values A maximum of 32 ASCII characters.

ve-id

ve-id command
Item Description
Syntax ve-id ve-id-value
Context configure>service>vpls>bgp-vpls>ve-name
Description This command configures a ve-id. Only one ve-id can be configured per BGP VPLS instance.
The VEID can be changed without shutting down the VPLS Instance. When the VE-ID changs,
BGP is withdrawing its own previously advertised routes and sending a route-refresh to all the
peers which would result in reception of all the remote routes again. The old PWs are removed
and new ones are instantiated for the new VE-ID value.
The no form of the command removes the configured ve-id. It can be used only when the BGP
VPLS status is shutdown. Command "no shutdown" cannot be used if there is no ve-id
configured.
Default no ve-id
Parameters value — A two bytes identifier that represents the local instance in a VPLS and is advertised
through the BGP NLRI. Must be lower than or equal to the max-ve-id.
Values 1..65535
shutdown
shutdown command
Item Description
Syntax [no] shutdown
Context configure>service>vpls>bgp-vpls
3HH-11985-AAAA-TQZZA
Virtual Private LAN Service
277