Table 242 Report-Src-Ip Command; Table 243 Robust-Count Command; Report-Src-Ip - Nokia 7302 Manual

Virtual Private LAN Service
5.16.6.8
Table 242
5.16.6.9
Table 243
314

report-src-ip

report-src-ip command
Item Description
Syntax report-src-ip ip-address
no report-src-ip
Context configure>service>vpls>igmp-snooping
Description This parameter specifies the source IP address used when generating IGMP reports.
According the IGMPv3 standard, a zero source address is allowed in sending IGMP reports.
However, for interoperability with some multicast routers, the source IP address of IGMP group
reports can be configured using this command.
Default 0.0.0.0
Parameters ip-address — The source IP address in transmitted IGMP reports.
robust-count
robust-count command
Item Description
Syntax robust-count robust-count
no robust-count
Context configure>service>vpls>igmp-snooping
configure>service>vpls>sap>igmp-snooping
configure>service>pw-template>igmp-snooping
Description If the send-queries command is enabled, this parameter allows tuning for the expected packet
loss on an SAP. The robust-count variable allows tuning for the expected packet loss on a
subnet and is comparable to a retry count. If this an SAP is expected to be 'lossy', this
parameter may be increased. IGMP snooping on this SAP is robust to (robust-count-1) packet
losses.
If send-queries is not enabled, this parameter will be ignored.
Default 20
Parameters robust-count — Specifies the robust count for the SAP.
Values: 2 — 7
3HH-11985-AAAA-TQZZA
FD 100/320Gbps NT and FX NT IHub Services Guide
Issue: 13