Simulating machining
7.7 Program control during simulation
Procedure
Toggling between "Override +" and "Override -"
Selecting the maximum feedrate
7.7.2
Simulating the program block by block
You have the capability of controlling the program execution during the simulation, i.e. to
execute a program, e.g. program block by program block.
Procedure
182
1.
Simulation is started.
2.
Press the "Program control" softkey.
3.
Press the "Override +" or "Override -" softkey to increase or decrease the
feedrate by 5%, respectively.
- OR -
Press the "100% override" softkey to set the feedrate to 100%.
- OR -
Press the "<<" softkey to return to the main screen and perform the sim‐
ulation with changed feedrate.
Simultaneously press the <Ctrl> and <cursor down> or <cursor up> keys to
toggle between the "Override +" and "Override -" softkeys.
Press the <Ctrl> and <M> keys simultaneously to select the maximum fee‐
drate of 120%.
1.
Simulation is started.
2.
Press the "Program control" and "Single block" softkeys.
Operating Manual, 05/2017, A5E40868517
Universal