Simple Search Target Definition - Siemens SINUMERIK 840D sl Operating Manual

Machining the workpiece
6.7 Starting execution at a specific point
6.7.3

Simple search target definition

Requirement
The program is selected and the controller is in Reset mode.
Procedure
6.7.4 Defining an interruption point as search target
Requirement
A program was selected in "AUTO" mode and interrupted during execution through CYCLE
STOP or RESET.
110
1. Press the "Block search" softkey.
2. Place the cursor on a particular program block.
- OR -
Press the "Find text" softkey, select the search direction, enter the
search text and confirm with "OK".
3. Press the "Start search" softkey.
The search starts. Your specified search mode will be taken into ac‐
count.
The current block will be displayed in the "Program" window as soon
as the target is found.
4. If the located target (for example, when searching via text) does not
correspond to the program block, press the "Start search" softkey again
until you find your target.
Press the <CYCLE START> key twice.
Processing is continued from the defined position.
Software option
You require the "Extended operator functions" option (only for 828D).
Operating Manual, 05/2017, A5E40868517
Universal