Samsung CLX-9350ND Service Manual page 409

● Code :
H1-1311
H1-1317
H1-1318
● Symptom / Cause :
Paper transport jam (paper Input section)
- The paper from the tray3 has not reached the tray3 fe
feed sensor.
- When you open and close the take away (DCF, HCF
sensor.
● Troubleshooting method : ● Troubleshooting method :
1. Open the side & take away door. Remove the jamm
Close the Side door. After warm up, if same jam occ
2. Open the side & take away. Remove the jammed pa
and tray2 feed roller. If there is any defective part in th
3. If the white idle roller of the take away door breaks a
roller.
4. Check if the wall connector of tray3 pick up unit is co
5. Enter the diagnostic mode, and check the feed sens g
If the paper is at sensor and "Without paper" messag
6. Check if the connector of the tray3 pick up unit on th
it.
7. Replace the DCF (or HCF) controller.
● Replacement part
- JC95-01034A (COVER-TAKE AWAY)
- JC93-00070A (FRAME MAIN-PICK UP)
- JC93-00174A (FRAME MAIN-PICK UP SECOND)
Service Manual
CLX-9250/9350 series
7. Troubles
● Error message :
Paper jam inside of m
,
shooting
machine.
eed sensor within normal time after passing the tray4
) door, the paper has jammed at the tray3 feed
med paper.
curs, check the following.
aper between the feed roller of the tray3 pick up unit
is area, replace it.
away, release the inner cover and reassemble the idle
onnected properly. Reconnect the connector.
sor test of the tray1 pick up unit. y p
ge is displayed, replace the sensor.
he pick up drive unit is connected properly. Reconnect
7-6 69
p
SAMSUNG ELECTRONICS