Eeprom And Photo Sensor - Samsung CLX-9350ND Service Manual

3.5.6 EEPROM and photo sensor

Perform the following procedure to remove the EEPRO
1. Remove the Fuser front. (Refer to 3.5.3 step 2~3)
2. Remove the EEPROM[A] after removing 2 connector
3. Remove the photo sensor shield after removing 1 scr
[A]
4. Remove the photo sensor [C] from the shield [B]. 4 R th h t
Service Manual
CLX-9250/9350 series
3. Replacemen
( p
[B]
[C] f th hi ld [B]
[C]
nt Procedures
M and Photo Sensor from the Fuser Unit.
)
rs, 1 screw and opening the wire saddle.
rew.
CAUTION
Be careful not to damage in harness.
The damage of the harness can make a fire
caused by a short circuit.
The EERPROM can be damaged by a
electrical or physical shock.
3-3 37
SAMSUNG ELECTRONICS