Rackmount Installation; Cable Connections - HP 4200 User Manual

Rackmount Installation

The appliance may be rack-mounted into industry-standard instrument/computer racks. The appliance is
shipped with a pair of rack-mount brackets with four screws. There are also four screws for mounting the
brackets to the appliance in the rack.
The appliance requires 1.5 rack units (RU) of vertical space. It does not require rails for rack mounting.
Note: The rackmount installation should be performed by an experienced individual, using appropriate tools,
and exercising appropriate safety precautions.
Use the following procedure to perform the rackmount installation:
1. Attach the rackmount brackets to the sides of the appliance.
2. Position the appliance in the rack.
3. Install the appliance into the rack. Use all of the provided screws in both vertical rails of the rack.
Caution: To prevent unstable mounting of the appliance, Hewlett-Packard recommends using two
screws per bracket.
4. Now the cables should be

Cable Connections

Use the following steps to connect the cables:
1. DB-9 Serial Port (supports all APC uninterruptible power supplies with a Simple Signaling cable
(APC part # 940-0020B))
2. RJ-45 Network Jack
3. Power Receptacle
1. Connect a twisted pair network cable (not included) with an RJ-45 connector to the RJ-45 jack on the
back of the appliance (see Figure 1, number 2).
2. Connect the other end of the network cable to a network port.
3. If using an APC uninterruptible power supply (UPS), connect a Simple Signaling cable from the UPS to
the DB-9 serial port on the back of the appliance.
connected.