HP 4200 User Manual page 128

Category: Security
Description: The appliance was unable to communicate with a Primary Domain Controller
(PDC) or a Backup Domain Controller (BDC) (if one is set up) to verify the user's name and
password. This means that clients will not be allowed to print because a Domain Controller was
not available to verify the user's name and password.
Action:
Check your WINS server, domain controllers, routers, and other network infrastructure to
verify proper set up and operation (are they plugged in and turned on?).
If you specified automatic discovery of the domain controllers on the
Networking Settings
same page.
If the DNS server, WINS server, or Domain Controller is not on the same subnet as the
appliance, ensure that the TCP/IP configurations, as entered on the
Settings page
infrastructure, such as the default gateway, is configured and is operational.
If the problem persists, try specifying the list of Domain Controllers using IP addresses
instead of NetBIOS or DNS names.
Authentication failed -- user authentication via Microsoft networking was unsuccessful (203)
Level: Error
Category: Security
Description:The user attempted to access the appliance via NT native tools, but the request was
denied because either the user identity was not confirmed or the user was not authorized to use
the appliance. One or more of the following errors may have occurred:
The user name and password combination was not valid.
The user logged into a machine that was not joined to the NT domain.
Action:
Retype the user name and password combination.
If the user machine was not in the same domain as the appliance or was not in a trusted
domain, the user should type domain\user name and password for correct authentication.
Verify that the user account exists.
Monitor the log file for additional unauthorized access attempts.
Permission denied - user not allowed to connect to printer (205)
Level: Error
Category: Security
Description: The user tried to perform an action without the proper access level.
Action:
If NT Domain authentication has been enabled on the
page, try changing to a list of specific domain controllers on that
in the web interface, are configured correctly and that the network
Microsoft
TCP/IP Network
Microsoft Networking Settings