Table of Contents
Advertisement
Headphone Volume Adjustment
Adjust the volume of the headphone while recording.
1
Connect the headphone to the headphone output terminal.
2
Press the
/
≥ Actual volume to be recorded does not change.
3
Press the SET button to complete the setup.
AUTO REC function
Recording control of this unit from the SDI output device or recording control of the external device (such as recorder)
from this unit can be performed with the AUTO REC signal.
AUTO REC input
This unit can automatically start/stop recording following the AUTO REC signal input from the camera recorder
connected to the SDI IN terminal.
≥ For information about supported devices, refer to the support desk section of the website below.
http://pro-av.panasonic.net/
Select the menu.
: [RECORD SETUP] # [AUTO REC INPUT] # desired setting
[OFF]:
Does not start/stop recording automatically.
[TYPE1]:
Starts/stops recording automatically following the TYPE1 information added to HD-SDI.
[TYPE2]:
Starts/stops recording automatically following the TYPE2 information added to HD-SDI.
[TYPE3]:
Starts/stops recording automatically following the TYPE3 information added to HD-SDI.
≥ The input and recording may not match when the interval between start/stop times is small (1 second or less), or
when the input signal is disrupted.
≥ To set to anything other than [OFF], always turn on this unit and connect to a camera recorder in the recording
pause status.
AUTO REC output
Recording control of the external device (such as recorder) connected to the SDI OUT terminal can be performed by
outputting the AUTO REC signal.
∫ Set the AUTO REC output of this unit
Set [SDI REMOTE REC] to switch the setup of AUTO REC signal output from this unit.
Select the menu.
: [OUTPUT SETUP] # [SDI REMOTE REC] # desired setting
[TYPE3]:
TYPE3 AUTO REC signal can be output.
[OFF]:
AUTO REC signal is not output.
buttons to adjust the volume.
- 81 -
VOL 12
A [VOL]
Advertisement
Table of Contents
