Table of Contents
Advertisement
Playback
∫
Problem
Clips/still pictures cannot be
played back.
Clips/still pictures cannot be
deleted.
With other products
∫
Problem
Although this unit is
correctly connected to an
external monitor, images
cannot be seen.
The images are squeezed
horizontally.
Even when this unit is
connected to the external
monitor by the HDMI cable,
images or sounds are not
output.
If the SD card is inserted in
another device, it is not
recognized.
With a PC
∫
Problem
When connected by the USB
Cable, this unit is not
detected by the PC.
When the USB Cable is
disconnected, an error
message will appear on the
PC.
Others
∫
Problem
If the SD card is inserted in
this unit, it is not recognized.
≥ Any clips/still pictures where the thumbnails are displayed as
be played back.
≥ In most cases,
j Clips recorded with another device or edited with editing software
j Clips with damaged data
≥ The thumbnails of clips with different system frequencies are indicated with
. You can play them back by changing the [SYSTEM FREQ] setting.
(l
40)
≥ Release the protect setting.
≥ It may not be possible to delete the following clips/still pictures:
j any clips/still pictures where the thumbnails are displayed as
If the clips/still pictures are unnecessary, format the SD card to erase the
data.
(l
40) Please be aware that if a SD card is formatted then all the data
recorded on the SD card is erased and cannot be recovered. Back up
important data on a PC etc.
≥ Please read the operating instructions of your external monitor and select the
channel that matches the input used for the connection.
≥ Change the setting of the unit depending on the cable connecting to the
external monitor.
(l
≥ Check if the HDMI cable is connected correctly.
≥ Insert the HDMI cable all the way in.
≥ Check what signals are supported by the HDMI monitor.
≥ Check that the device is compatible with the capacity or type of SD card
(SDHC Memory Card/SDXC Memory Card) that you inserted. Refer to the
operating instructions of the device for details.
≥ After re-inserting the SD card into the unit, reconnect the USB Cable.
≥ Select another USB terminal on the PC.
≥ Check the operating environment.
≥ Connect the USB Cable again after restarting the PC and turning on this unit
again.
≥ To disconnect the USB Cable safely, double-click the
tray and follow the instructions on the screen.
≥ If the SD card is formatted on a PC, it may not be recognized by this unit. Use
this unit to format SD cards.
- 245 -
Check points
is displayed for the following clips:
(l
90)
Check points
96)
Check points
(l
105)
Check points
(l
40)
cannot
icon in the task
Advertisement
Table of Contents
