HP 10500 SERIES Configuration Manual page 47

Step
2. Configure an IPv6 static route
for an IPv6 VPN instance.
Configuring RIPng between IPv6 MCE and VPN site
A RIPng process belongs to the public network or a single IPv6 VPN instance. If you create a RIPng
process without binding it to an IPv6 VPN instance, the process belongs to the public network. By
configuring RIPng process-to-IPv6 VPN instance bindings on an IPv6 MCE, you allow routes of different
VPNs to be exchanged between the IPv6 MCE and the sites through different RIPng processes, ensuring
the separation and security of IPv6 VPN routes.
For more information about RIPng, see Layer 3—IP Routing Configuration Guide.
To configure RIPng between IPv6 MCE and VPN site:
Step
1. Enter system view.
2. Create a RIPng process for a
VPN instance and enter RIPng
view.
3. Redistribute remote site routes
advertised by the PE.
4. Configure the default cost
value for the redistributed
routes.
5. Return to system view.
6. Enter interface view.
7. Enable RIPng on the interface.
Configuring OSPFv3 between IPv6 MCE and VPN site
An OSPFv3 process belongs to the public network or a single IPv6 VPN instance. If you create an
OSPFv3 process without binding it to an IPv6 VPN instance, the process belongs to the public network.
By configuring OSPFv3 process-to-IPv6 VPN instance bindings on an IPv6 MCE, you allow routes of
different IPv6 VPNs to be exchanged between the IPv6 MCE and the sites through different OSPFv3
processes, ensuring the separation and security of IPv6 VPN routes.
Command
•
ipv6 route-static ipv6-address prefix-length
{ interface-type interface-number
[ next-hop-address ] | next-hop-address |
vpn-instance d-vpn-instance-name
nexthop-address } [ preference
preference-value ]
•
ipv6 route-static vpn-instance
s-vpn-instance-name&<1-6> ipv6-address
prefix-length { interface-type
interface-number [ next-hop-address ] |
nexthop-address [ public ] | vpn-instance
d-vpn-instance-name nexthop-address }
[ preference preference-value ]
Command
system-view
ripng [ process-id ] vpn-instance
vpn-instance-name
import-route protocol [ process-id ]
[ allow-ibgp ] [ cost cost |
route-policy route-policy-name ] *
default cost value
quit
interface interface-type
interface-number
ripng process-id enable
Remarks
Use either command.
Perform this
configuration on the
IPv6 MCE. On a VPN
site, configure normal
IPv6 static routes.
Remarks
N/A
Perform this configuration on the
IPv6 MCE. On a VPN site,
configure normal RIPng.
By default, no route of any other
routing protocol is redistributed
into RIPng.
Optional.
0 by default.
N/A
N/A
Disabled by default.