HP 10500 SERIES Configuration Manual page 157

Record Route
FRR Flag
BackUpBW Type
Route Pinning
Retry Limit
Reopt
Back Up Type
Back Up LSPID
Auto BW
Min BW
Current Collected BW:
Interfaces Protected:
VPN Bind Type
VPN Bind Value
Car Policy
Tunnel Group
Primary Tunnel
Backup Tunnel
Group Status
Configure a bypass tunnel on Switch B (the PLR):
5.
# Create an explicit path for the bypass LSP.
[SwitchB] explicit-path by-path
[SwitchB-explicit-path-by-path] next hop 3.2.1.2
[SwitchB-explicit-path-by-path] next hop 3.3.1.2
[SwitchB-explicit-path-by-path] next hop 3.3.3.3
[SwitchB-explicit-path-by-path] quit
# Create the bypass tunnel.
[SwitchB] interface tunnel 5
[SwitchB-Tunnel5] ip address 11.1.1.1 255.255.255.0
[SwitchB-Tunnel5] tunnel-protocol mpls te
[SwitchB-Tunnel5] destination 3.3.3.3
[SwitchB-Tunnel5] mpls te tunnel-id 15
[SwitchB-Tunnel5] mpls te path explicit-path by-path preference 1
# Configure the bandwidth that the bypass tunnel protects.
[SwitchB-Tunnel5] mpls te backup bandwidth 10000
[SwitchB-Tunnel5] mpls te commit
[SwitchB-Tunnel5] quit
# Bind the bypass tunnel with the protected interface.
[SwitchB] interface Vlan-interface 2
[SwitchB-Vlan-interface2] mpls te fast-reroute bypass-tunnel tunnel 5
[SwitchB-Vlan-interface2] quit
# Execute the display interface tunnel command on Switch B. You can see that Tunnel5 is up.
# Execute the display mpls lsp command on each switch.
[SwitchA] display mpls lsp
------------------------------------------------------------------
------------------------------------------------------------------
: Enabled
: Enabled
: -
: Disabled
: 10
: Disabled
: None
: -
: Disabled
: -
-
-
: NONE
: -
: Disabled
: Primary
: -
: -
: -
LSP Information: RSVP LSP
149
Record Label : Enabled
BackUpBW Flag: Not Supported
BackUpBW : -
Retry Interval:
Reopt Freq
Auto BW Freq :
Max BW
10 sec
: -
-
: -