HP 10500 SERIES Configuration Manual page 373

[PE2] ip vpn-instance vpn1
[PE2-vpn-instance-vpn1] route-distinguisher 200:1
[PE2-vpn-instance-vpn1] vpn-target 111:1
[PE2-vpn-instance-vpn1] quit
[PE2] ip vpn-instance vpn2
[PE2-vpn-instance-vpn2] route-distinguisher 200:2
[PE2-vpn-instance-vpn2] vpn-target 222:2
[PE2-vpn-instance-vpn2] quit
[PE2] interface vlan-interface 11
[PE2-Vlan-interface11] ip binding vpn-instance vpn1
[PE2-Vlan-interface11] ipv6 address 2001:3::2 96
[PE2-Vlan-interface11] quit
[PE2] interface vlan-interface 13
[PE2-Vlan-interface13] ip binding vpn-instance vpn2
[PE2-Vlan-interface13] ipv6 address 2001:4::2 96
[PE2-Vlan-interface13] quit
# Configure IP addresses for the CEs according to
After completing the configurations, issue the display ip vpn-instance command on the PEs to
display the configuration of the VPN instance. Use the ping command to test connectivity between
the PEs and their attached CEs. The PEs can ping their attached CEs. Take PE 1 as an example:
[PE1] display ip vpn-instance
Total VPN-Instances configured : 2
VPN-Instance Name
vpn1
vpn2
[PE1] ping ipv6 -vpn-instance vpn1 2001:1::1
PING 2001:1::1 : 56
Reply from 2001:1::1
bytes=56 Sequence=1 hop limit=64
Reply from 2001:1::1
bytes=56 Sequence=2 hop limit=64
Reply from 2001:1::1
bytes=56 Sequence=3 hop limit=64
Reply from 2001:1::1
bytes=56 Sequence=4 hop limit=64
Reply from 2001:1::1
bytes=56 Sequence=5 hop limit=64
--- 2001:1::1 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 1/1/1 ms
Establish EBGP peer relationships between the PEs and CEs to allow them to exchange VPN
4.
routes:
# Configure CE 1.
<CE1> system-view
[CE1] bgp 65410
RD Create Time
100:1 2006/08/13 09:32:45
100:2 2006/08/13 09:42:59
data bytes, press CTRL_C to break
time = 1 ms
time = 1 ms
time = 1 ms
time = 1 ms
time = 1 ms
365
Figure 45. (Details not shown.)