Configuring Mpls L3Vpns Using Ibgp Between Pe And Ce - HP 10500 SERIES Configuration Manual

Request time out
Request time out
Request time out
--- 10.4.1.1 ping statistics ---
5 packet(s) transmitted
0 packet(s) received
100.00% packet loss

Configuring MPLS L3VPNs using IBGP between PE and CE

Network requirements
CE 1 and CE 3 belong to VPN 1. CE 2 and CE 4 belong to VPN 2.
VPN 1 uses route target attribute 1 1 1:1. VPN 2 uses route target attribute 222:2. Users of different VPNs
cannot access each other.
IBGP is used to exchange VPN routing information between CE and PE.
PEs use OSPF to communicate with each other and use MP-IBGP to exchange VPN routing information.
Figure 32 Network diagram
Device
PE 1
CE 1
CE 2
CE 3
Interface IP address
Loop0 1.1.1.9/32
Vlan-int11 10.1.1.2/24
Vlan-int13 172.1.1.1/24
Vlan-int12 10.2.1.2/24
Loop0 4.4.4.9/32
Vlan-int11 10.1.1.1/24
Loop0 5.5.5.9/32
Vlan-int12 10.2.1.1/24
Loop0 6.6.6.9/32
Vlan-int11 10.3.1.1/24
Device Interface
PE 2 Loop0
Vlan-int12
Vlan-int11
Vlan-int13
P Loop0
Vlan-int12
Vlan-int13
CE 4 Loop0
Vlan-int13
280
IP address
3.3.3.9/32
172.2.1.2/24
10.3.1.2/24
10.4.1.2/24
2.2.2.9/32
172.2.1.1/24
172.1.1.2/24
7.7.7.9/32
10.4.1.1/24