Mpls Te Using Rsvp-Te Configuration Example - HP 10500 SERIES Configuration Manual

# Create a static route to direct traffic to the MPLS TE tunnel.
[SwitchA] ip route-static 3.2.1.2 24 tunnel 0 preference 1
# Execute the display ip routing-table command on Switch A. You can see a static route entry with
interface Tunnel 0 as the outgoing interface.

MPLS TE using RSVP-TE configuration example

Network requirements
Switch A, Switch B, Switch C, and Switch D are running IS-IS and all of them are Level-2 devices.
Use RSVP-TE to create a TE tunnel with 2000 kbps of bandwidth from Switch A to Switch D, making sure
the maximum bandwidth of each link that the tunnel traverses is 10000 kbps and the maximum
reservable bandwidth is 5000 kbps.
Figure 32 Network diagram
Device
Switch A
Switch B
Configuration procedure
Configure IP addresses and masks for interfaces according to
1.
Enable IS-IS to advertise host routes with LSR IDs as destinations:
2.
# Configure Switch A.
<SwitchA> system-view
[SwitchA] isis 1
[SwitchA-isis-1] network-entity 00.0005.0000.0000.0001.00
[SwitchA-isis-1] quit
[SwitchA] interface vlan-interface 1
[SwitchA-Vlan-interface1] isis enable 1
[SwitchA-Vlan-interface1] isis circuit-level level-2
[SwitchA-Vlan-interface1] quit
[SwitchA] interface loopback 0
[SwitchA-LoopBack0] isis enable 1
[SwitchA-LoopBack0] isis circuit-level level-2
Interface IP address
Loop0 1.1.1.9/32
Vlan-int1 10.1.1.1/24
Loop0 2.2.2.9/32
Vlan-int1 10.1.1.2/24
Vlan-int2 20.1.1.1/24
Device Interface
Switch D Loop0
Vlan-int3
Switch C Loop0
Vlan-int3
Vlan-int2
132
IP address
4.4.4.9/32
30.1.1.2/24
3.3.3.9/32
30.1.1.1/24
20.1.1.2/24
Figure 32. (Details not shown.)