Verifying Services - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
----End

12.4.3.7 Verifying Services

This topic describes how to verify the Layer 2 interoperation service by checking the service
configurations, service port status, and connectivity between PCs in different branches of an
enterprise.
Prerequisites
PCs (with different MAC addresses) connected to different ONUs have been configured. Ensure
that the IP addresses of the PCs are in the same network segment or subnet segment.
Procedure
Step 1 Check whether the VLAN configurations are correct.
huawei(config)#display vlan 300
{ <cr>|inner-vlan<K>|to<K> }:
Command:
VLAN ID: 300
VLAN type: smart
VLAN attribute: common
VLAN description:
VLAN forwarding mode in control board: VLAN-MAC
VLAN forwarding mode: VLAN-MAC
VLAN broadcast packet forwarding policy: forward
VLAN unknown multicast packet forwarding policy: forward
VLAN unknown unicast packet forwarding policy: forward
VLAN bind service profile ID: 1
VLAN bind RAIO profile index: -
VLAN priority: -
Standard port number: 0
---------------------------------------------------------
INDEX
---------------------------------------------------------
---------------------------------------------------------
Service virtual port number: 2
Note: F--Frame, S--Slot, P--Port,
huawei(config)#display vlan service-profile profile-id 1
Profile
Profile Name: srvprof-1
Issue 01 (2014-04-30)
lineprofile-id 10
huawei_A(config-if-gpon-0/3)#quit
huawei_A(config)#protect-group 1 protect-target gpon-uni-ont workmode dual-
parenting
huawei_A(protect-group-1)#protect-group member port 0/3/1 ont 1 role work
Configurations on the standby OLT huawei_B:
huawei_B(config)#interface gpon 0/3
huawei_B(config-if-gpon-0/3)#ont add 1 1 sn-auth 32303131B39FD641 snmp ont-
lineprofile-id 10
huawei_B(config-if-gpon-0/3)#quit
huawei_B(config)#protect-group 1 protect-target gpon-uni-ont workmode dual-
parenting
huawei_B(protect-group-1)#protect-group member port 0/3/1 ont 1 role protect
huawei_B(protect-group-1)#protect-group enable
display vlan 300
TYPE STATE F/ S/ P
10 gpon up 0/3 / 1
11 gpon up 0/3 / 1
VPI indicates ONT ID for PON, VCI indicates GEM index for GPON,
v/e--vlan/encap, pri-tag--priority-tagged
ID: 1
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
12 FTTO Configuration(SOHO and SME)
VPI VCI FLOWTYPE FLOWPARA
1 12 vlan 300
2 12 vlan 300
1247