Access Point Profile Vap Configuration; Figure 389: Ap Profile Vap Configuration; Table 356: Default Vap Configuration - D-Link DWL-8600AP User Manual

D-Link UWS User Manual

Access Point Profile VAP Configuration

The Access Point Profile VAP Configuration page displays the virtual access point (VAP) settings associated
with the selected AP profile. Each VAP is identified by its network number and Service Set Identifier (SSID). You
can configure and enable up to 16 VAPs per radio on each physical access point.
The following table describes the fields on the Access Point Profile VAP Configuration page.
Field
1-802.11a/n
2-802.11b/g/n
D-Link
Oct. 2015

Figure 389: AP Profile VAP Configuration

Table 356: Default VAP Configuration

Description
From this field, you can select the radio with the settings to configure. Settings for
each radio are configured separately.
By default, Radio 1 operates in IEEE 802.11a/n mode, and Radio 2 operates in IEEE
802.11b/g/n mode. If you change the mode, the labels for the radios change
accordingly. Changes to the settings apply only to the selected radio.
The DWL-3600AP is a single-radio AP. Any settings you configure for Radio 1
(802.11a/n) are not applied to the DWL-3600AP. If the selected Hardware Type ID for
the AP profile is DWL-3600AP, the radio selectors are not available.
Configuring Advanced Settings
Unified Wired and Wireless Access System
Page 619