D-Link UWS User Manual
Field
Route Type
Network Address
Subnet Mask
Next Hop IP Address
Preference
4. Click Submit.
The new route is added, and you are returned to the Configured Routes page.
Deleting a Route
Select the check box at the end of the row for the route to delete. Click Delete to remove the selected route.
D-Link
Oct. 2015
Figure 205: Create Static Route
Table 187: Route Entry Create Fields
Description
Specifies whether the route is to be a Default, Static, or Static Reject route.
Packets sent to the static reject route are dropped.
Specify the IP route prefix for the destination from the dropdown menu. In
order to create a route, a valid routing interface must exist and the next hop
IP Address must be on the same network as the routing interface. Routing
interfaces are created on the IP Interface Configuration page. Valid next hop
IP Addresses can be viewed on the Route Table page.
Also referred to as the subnet/network mask, this indicates the portion of the
IP interface address that identifies the attached network.
The outgoing router IP address to use when forwarding traffic to the next
router (if any) in the path towards the destination. The next router is always
one of the adjacent neighbors or the IP address of the local interface for a
directly attached network. When creating a route, the next hop IP must be on
the same network as the routing interface. Valid next hop IP Addresses can be
seen on the Route Table page.
Specifies a preference value for the configured next hop.
Unified Wired and Wireless Access System
Router
Page 318