D-Link DWL-8600AP User Manual page 112

D-Link UWS User Manual
Field
Ucast Storm Level
LACP Mode
Physical Mode
Physical Status
Link Status
Link Trap
• Click Refresh to display the most current information from the router.
D-Link
Oct. 2015
Table 34: Port Summary Fields (Cont.)
Description
Shows the Unicast Storm Recovery Level, which is the data rate at which
storm control activates. The value is a percentage of port speed and ranges
from 0-100.The factory default is 5 percent of port speed.
Indicates the Link Aggregation Control Protocol administration state. The
mode must be enabled in order for the port to participate in Link Aggregation.
This field can have the following values:
• Enable: Specifies that the port is allowed to participate in a port channel
(LAG), which is the default mode.
• Disable: Specifies that the port cannot participate in a port channel (LAG).
Shows the speed and duplex mode at which the port is configured:
• Auto: The duplex mode and speed will be set by the auto-negotiation
process. The port's maximum capability (full duplex and 100 Mbps) will be
advertised.
• <Speed> Half Duplex: The port speeds available from the menu depend on
the platform on which the D-Link DWS-4000 Series software is running and
which port you select. In half-duplex mode, the transmissions are one-
way. In other words, the port does not send and receive traffic at the same
time.
• <Speed> Full Duplex: The port speeds available from the menu depend on
the platform on which the D-Link DWS-4000 Series software is running and
which port you select. In half-duplex mode, the transmissions are two-
way. In other words, the port can send and receive traffic at the same time.
Indicates the port speed and duplex mode at which the port is operating.
Indicates whether the Link is up or down.
This object determines whether or not to send a trap when link status
changes. The factory default is enabled.
• Enable: Specifies that the system sends a trap when the link status
changes.
• Disable: Specifies that the system does not send a trap when the link
status changes.
Configuring and Viewing Device Port Information
Unified Wired and Wireless Access System
Page 112