Reset The System; Restore Configuration To Factory Defaults (Delete Configuration Files); Activate Backup Image - D-Link DWL-8600AP User Manual

D-Link UWS User Manual

Reset the System

Use option 10 to clear all flash and reset the system to its default setting. User action is confirmed with a Y/N
question before executing the command.
To reset the system from the Boot menu:
1. On the Boot menu, select 10 and press <Enter>.
The following prompt displays:
[Boot Menu] 10
Are you SURE you want to reset the system? (y/n):y
Boot code......
SDRAM 256
Boot Menu Version: Oct 20 2004
Select an option. If no selection in 10 seconds then operational code will start.
1 - Start operational code.
2 - Start Boot Menu.
Select (1, 2):2
2. The bootup process resumes.

Restore Configuration To Factory Defaults (Delete Configuration Files)

Use option 11 to load using the system default configuration and to boot without using the current startup
configuration. Selecting 11 from the Boot Menu restores system defaults. Boot Sequence can then be started
by selecting 1 from the Boot Menu.
To download software from the Boot menu:
1. On the Boot menu, select 11 and press <Enter>.
The following prompt displays:
Are you SURE you want to delete the configuration? (y/n):y
2. The bootup process resumes.

Activate Backup Image

Use option 12 to activate the backup image. The active image becomes the backup when this option is
selected.
To activate the backup image:
1. From the Boot menu, select 12 and press <Enter>.
The following message displays:
Backup image - image2 activated.
2. The bootup process resumes.
D-Link
Oct. 2015
Booting the Switch
Unified Wired and Wireless Access System
Page 55