General Operating Sequences; Program Overview And Program Selection - Siemens SINUMERIK 840D Operator's Manual

2
03.04
2.5

General operating sequences

Keys
Functions

2.5.1 Program overview and program selection

Select
program
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition

2.5 General operating sequences

A range of keys and menus is provided in the various operating areas.
The function of the keys and menus is the same in all operating areas.
The following section describes functions which you can select in
several operating modes.
Function
After selection of a workpiece or program overview, individual
workpieces or programs can be enabled or disabled for execution.
Operating sequence
"AUTO" is selected in the "Services" or "Machine" operating area.
The appropriate channel is selected.
The channel is in reset state.
The workpiece/program to be selected is in the memory.
An overview of all workpiece directories/programs that exist is
displayed.
Position the cursor on the desired workpiece/program.
Select the workpiece/program for execution:
The name of the selected workpiece is displayed on the screen in field
"Program name" at the top. The program is then loaded.
Operator Components/Operating Sequences
2
2-49