Other Types Of Setting Data - Siemens SINUMERIK 840D Operator's Manual

5
03.04
Setting
data
Starting
angle

5.7.6 Other types of setting data

Setting
data
Misc.
General
SD
Channel-
specific SD
Axis-
specific SD
Find
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
Operating sequence
Select softkey "Setting data".
The vertical softkey bar changes.
Change starting angle:
Select softkey "Starting angle".
The "Starting angle for thread" window opens.
Enter a new value.
Function
All the setting data in the control are displayed in tabular form sorted
according to general (i.e. NCK-specific), channel-specific and axis-
specific setting data. The table contains both the setting data on the
vertical softkeys such as working area limitation, Jog data etc., as well
as special setting data such as software cam, oscillation,
compensation etc.
Operating sequence
Select softkey "Setting data".
The vertical softkey bar changes.
Display setting data:
Select softkey "Misc.".
The horizontal and vertical softkey bars change.
Select the type:
•
The "General setting data ($SN_)" window is opened.
•
The "Channel-specific setting data ($SC_)" window is opened.
•
The "Axis-specific setting data ($SA_)" window is opened.
The current setting data of the corresponding type $SN_, $SC_or
$SA_ are displayed.
Find setting data:
In the "Find setting data" window enter the name or number you are
looking for (initial identifier is enough).
Parameters Operating Area
5.7 Setting data
5
5-185