Siemens SINUMERIK 840D Operator's Manual page 4

SINUMERIK® Documentation
Printing history
Brief details of this edition and previous editions are listed below.
The status of each edition is shown by the code in the "Remarks" columns.
Status code in the "Remarks" column:
A .... New documentation.
B .... Unrevised reprint with new Order No.
C .... Revised edition with new status.
Edition Order No.
02.01 6FC5298-6AC00-0BP0
11.01 6FC5298-6AC00-0BP1
11.02 6FC5298-6AC00-0BP2
03.04 6FC5298-6AC00-0BP3
Trademarks

SIMATIC , SIMATIC HMI
trademarks of Siemens AG. The other designations in this publication may also be trademarks, the use of
which by third parties may constitute copyright violation
Additional information is available on the Internet under:
http://www.siemens.com/motioncontrol
This publication was produced with with WinWord V 7.0
and Designer V 4.0.
© Siemens AG, 1995-2004. All rights reserved
Order No. 6FC5298-6AC00-0BP3
Printed in Germany
 
, SIMATIC NET , SIROTEC
Remarks
A
C
C
C
 
, SINUMERIK and SIMODRIVE
.
Other functions not described in this documentation might be
executable in the control. This does not, however, represent an
obligation to supply such functions with a new control or when
servicing.
We have checked that the contents of this documentation correspond
to the hardware and software described. Nonetheless, differences
might exist and therefore we cannot guarantee that they are completely
identical. The information contained in this document is, however,
reviewed regularly and any necessary changes will be included in the
next edition. We welcome suggestions for improvement.
Subject to change without prior notice
Siemens Aktiengesellschaft

are registered