Siemens SINUMERIK 840D Operator's Manual page 143

5
03.04
Tool status
WZ type
T number
Geo - L1 ... Radius ...
Magazine
list
Tool
list
Load
Unload
Relocate
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
Tool status
No display = Replacement tool
A = Active tool
F = Tool enabled
G = Tool disabled
M = Measured tool
V = Warning limit reached
W = Tool is being changed
P = Fixed-location-coded tool
E = Tool was in use
Tool type
Depending on the tool type, only certain tool offsets are enabled for
selection when the tool is loaded. All other tool types are preset with
the value "0".
Internal T numbers which may be needed for reloading tool data.
Tool offsets such as length, radius, wear, monitoring data, etc.
Horizontal softkeys
The "Magazine list" basic display shows all the tools that are already
assigned to a magazine location ("loaded").
All tools which are stored as a set of data on the NC are displayed
(irrespective of whether or not they have been assigned to a
magazine location).
A magazine location is assigned to the tool.
The tool is deleted from the current magazine location.
The tool is moved from the current magazine location to another
location.
Parameters Operating Area
5.3 Tool management
5
5-143