Activate Remote Diagnosis - Siemens SINUMERIK 840D Operator's Manual

8
Diagnosis Operating Area

8.5 Activate remote diagnosis

Sync.
manual
Sync.
AUTO/ON
Sync.
AUTO/OFF
Machine manufacturer
8.5

Activate remote diagnosis

Remote
diagnosis
References
Machine manufacturer
8-294
The values set are retained when the software is rebooted.
Further information
You can also manually enter the time period for synchronization of the
HMI and PLC clock via softkey "Sync. manual".
You can activate cyclic (automatic) clock synchronization via the
"Sync. AUTO/ON" softkey and set the time duration for
synchronization there. Enter the correct values in the input fields.
Automatic synchronization is deactivated by pressing the "Sync.
AUTO/OFF" softkey. The HMI and PLC then run separately again.
Always refer to the information and specifications provided by the
machine manufacturer.
The remote diagnosis function is an option.
If this option is set, it is possible to control and influence the operation
of a PCU 20 from a remote PC, as well as to transmit data.
When you select the "Remote diagnosis" softkey, the vertical "Start"
and "End" softkeys appear. In this way you start or end the remote
diagnosis.
/IAM/ IM2: Installation & Start-up Guide HMI Embedded
Always refer to the information and specifications provided by the
machine manufacturer.
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
8
03.04
 Siemens AG, 2004. All rights reserved