Problems With Nec Expressbuilder; Problems With Express Setup - NEC Express5800 120Rj-2 User Manual

User Guide

Problems with NEC ExpressBuilder

When the server does not boot from the NEC ExpressBuilder DVD, check the
following:
■ Did you set the NEC ExpressBuilder during POST and restart the server?
- If you do not set the NEC ExpressBuilder during POST and restart the server,
an error message will appear or the OS will boot.
■ Is BIOS configuration correct?
- The boot device order may be specified with the CMOS Setup utility of the
server. Use the CMOS Setup utility to change the boot device order to boot the
system from the optical disc drive first.
<Menu to check: [Boot]>
If [OS installation ***default***] is selected at BOOT Selection screen, following
message is displayed.
After this message appears, check the error and take the appropriate corrective action
according to the message listed in the table below.
Message
This NEC ExpressBuilder version was not designed
for this computer.
Insert the correct version and click [OK]. (When you
click [OK], the computer reboots.)
NEC ExpressBuilder could not get the hardware
parameters written in this motherboard.
This version is not designed for this computer or the
motherboard may be broken. (When you click [OK],
the computer reboots.)
The hardware parameters written in this
motherboard are incorrect.
This version is not designed for this computer or the
motherboard may be broken.

Problems with Express Setup

The system partition is created by size smaller than specified value.
■ In Express Setup, there are some cases that the system partition created by size
about 8MB smaller than specified size.
It is not a problem in operating the system.
Following message appeared when you tried to install Express Setup to the hard
disk drive that has smaller capacity than the specified partition size:
■ Cannot continue the setup.
Specify smaller partition size than the capacity of connected hard disk drive, and
then retry the setup.
Cause
This NEC ExpressBuilder version is not designed for
this server.
Execute the NEC ExpressBuilder on the compliant
server.
This message is shown when NEC ExpressBuilder
could not find system-specific information because of
motherboard exchange and so on.
232
www.nec-computers.com