User Guide
Installation (USB File Devices)
1. See the section
2. Pull out the server from the rack.
3. Remove the logic cover and drive cover. See
"Logic Cover" on page 143
4. Remove the PCI riser module. See
page 166
5. Remove the support arm from the chassis.
Press firmly the support arm before removing the screws.
6. Remove the processor duct from the chassis.
"Preparing Your System for Upgrade" on page 137
.
Figure 168: Removing the Support Arm
Note: Loosen the screws when the support arm comes up.
Figure 169: Removing the Processor Air Duct
"Drive Cover" on page 141
.
"Installing and Removing a PCI Board" on
202
www.nec-computers.com
.
and