Maintenance And Service - Toro ProPass 200 Service Manual

Maintenance and Service

1. The Operator's Manual provides information regard-
ing the operation, general maintenance and mainte-
nance intervals for your ProPass machine. Refer to this
publication for additional information when servicing the
machine.
2. Before servicing or making adjustments, position
ProPass machine on a level surface. Engage tow ve-
hicle parking brake, stop engine and remove key from
the ignition switch. If ProPass is equipped with wireless
controller, power off wireless controller. On ProPass
mounted to a tow behind chassis, chock wheels to pre-
vent it from moving.
3. If equipped, press the E--stop button to disable the
ProPass electrical system before working on the ma-
chine. Pull the button out when machine is to be returned
to use.
4. Make sure machine is in safe operating condition by
keeping all nuts, bolts and screws tight.
5. Never store the machine or fuel container inside
where there is an open flame, such as near a water heat-
er or furnace.
6. Make sure all hydraulic line connectors are tight and
all hydraulic hoses and lines are in good condition be-
fore applying pressure to the hydraulic system.
7. Keep body and hands away from pin hole leaks in hy-
draulic lines that eject high pressure hydraulic fluid. Use
cardboard or paper to find hydraulic leaks. Hydraulic
fluid escaping under pressure can penetrate skin and
cause injury. Hydraulic fluid accidentally injected into the
skin must be surgically removed within a few hours by
a doctor familiar with this form of injury or gangrene may
result.
ProPass 200
8. Before disconnecting any hydraulic component or
performing any work on the hydraulic system, all pres-
sure in system must be relieved. See Relieving Hydrau-
lic System Pressure in the General Information section
of Chapter 3 -- Hydraulic System.
9. Make sure that electrical power harness from tow ve-
hicle is disconnected before working on the machine's
electrical system.
10.If major repairs are ever needed or assistance is de-
sired, contact your Authorized Toro Distributor.
11. At the time of manufacture, the machine conformed
to all applicable safety standards. To assure optimum
performance and continued safety certification of the
machine, use genuine Toro replacement parts and ac-
cessories. Replacement parts and accessories made
by other manufacturers may result in non-conformance
with the safety standards, and the warranty may be
voided.
12.When changing tires or performing other service on
your ProPass machine, use correct hoists and jacks.
Make sure machine is parked on a solid level surface
such as a concrete floor with the hopper empty. Always
chock or block wheels. Use appropriate stands to sup-
port the raised machine. If the machine is not properly
supported, the machine may move or fall, which may re-
sult in personal injury.
Page 1 - - 3 Safety