Canon A-200 series Service Manual page 23

5. Remove five screws securing the main Pc. B. to the chassis.
6. Move the main PC.B toward the front panel slightly, lift the left side of PC.B. and remove it
away from the chassis.
Main P.C.B.
FDD
Figure 3-9
111-1-4. Floppy Disk Drive Unit
Ground Wire
Signal Connector
Figure 3-10
1. Disconnect the signal and power cables from the FDD (Floppy Disk Drive). On the body
of the A-drive FDD, the ground wire is secured. Disconnect it by removing the screw.
Mounting Bracket
Figure 3-11
2. FDDs are mounted on the bracket. Remove two screws securing that bracket to the chassis.
3. Lift the bracket with FDDs away from the chassis. In this case, be careful not to touch internal
electrical or mechanical elements on the FDDs.
20