GE MapSight User Manual page 115

Reinserting or changing an SD card. Whenever you remove or change an SD card on your
MapSight, wait at least 6 seconds before inserting another card into the slot. Your MapSight
needs this short time delay to properly identify and use the newly inserted card. If a card is re-
inserted too quickly, your MapSight may need to reset.
programs before changing or re-inserting a card.
Copying data from an SD card or USB drive. You can run or copy data from a peripheral
device onto your MapSight by following these steps:
On your MapSight, tap Start > Programs > File Explorer
Tap and hold the file you want to copy to your MapSight. A
pop-up menu appears, as shown here.
Note: If you want to copy multiple files, tap and drag
the stylus over the files. Once the files are selected,
tap and hold the stylus on the files until a pop-up
menu appears.
Select Copy
Open the destination folder where you want to place your
copied file
Tap and hold the stylus on the white space below the
existing files until the pop-up menu appears again
Select Paste. The file is copied and its name appears on the screen
MapSight U ser M anual
MS-101-14-12-34.0
To avoid this problem, close all
Page 1 11 www.gemapsight.com/support