Panasonic TC0938450-015CE Operating Instructions Manual page 34

8 Configure the settings related to images [Image]
"Unlimited*" is available only when "Frame rate" is selected for "Transmission priority".
Note

When "Unlimited*" is selected, the number of users who can access H.264 images will be limited to "1".
(Only a single user can access H.264 images.)

The H.264 bit rate is restricted by "Bandwidth control(bit rate)" on the [Network] tab on the "Network" page
(section 13). For this reason, the bit rate may be lower than the value when any value with an asterisk (*)
on the right is selected.

It is impossible to select "Unlimited*" for both "H.264(1)" and "H.264(2)".
[Image quality]
Select the image quality of H.264 images from the following.
Low(Motion priority)/ Normal/ Fine(Image quality priority)

Default: Normal
Note

When "Constant bit rate" or "Best effort" is selected for "Transmission priority", this setting is available.
[Refresh interval]
Select an interval (I-frame interval; 0.2 - 5 seconds) to refresh the displayed H.264 images.
If using under a network environment with frequent error occurrences, shorten the refresh interval for H.264 to
diminish image distortions. However, the refresh interval may be longer than the set value.
0.2s/ 0.25s/ 0.33s/ 0.5s/ 1s/ 2s/ 3s/ 4s/ 5s
 Default: 1s
[Transmission type]
Select the transmission type of H.264 images from the following.

Unicast port (AUTO): Up to 14 users can access a single unit concurrently. "Unicast port" will
automatically be selected when transmitting images from the unit. When it is unnecessary to fix the
port number for H.264 image transmission such as when using in a particular LAN environment, it is
recommended to select"Unicast port (AUTO)".

Unicast port (MANUAL): Up to 14 users can access a single unit concurrently. It is necessary to select
"Unicast port" manually to transmit images from the unit.
It is possible to fix the port number of the router used for H.264 image transmission via the Internet by
setting "Unicast port (MANUAL)" (section 13). Refer to the operating instructions of the router in use.

Multicast: Unlimited number of users can access a single unit concurrently. Complete the entry field
of "Multicast address", "Multicast port" and "Multicast TTL/HOPLimit" when transmitting H.264 images
with multicast.

Default: Unicast port (AUTO)
[Unicast port]
*1
Enter the unicast port number (used to transmit images from the unit).

Available port number: 1024 - 50000 (Only even numbers are available.)

Default:
–
H.264(1): 32004
–
H.264(2): 32014
[Multicast address]
Enter the multicast IP address. Images will be transmitted to the designated IP address.
 Available IPv4 address: 224.0.0.0 - 239.255.255.255
 Available IPv6 address: Multicast address starting with "FF"
 Default:
–
H.264(1): 239.192.0.20
–
H.264(2): 239.192.0.21
Note
34 Operating Instructions
*2