Panasonic TC0938450-015CE Operating Instructions Manual page 33


When "On" is selected for "H.264 transmission" in "H.264(1)" and "H.264(2)", H.264 images are
viewable using other devices with each setting.

When "On" is selected for "H.264 transmission" in "H.264(1)" or "H.264(2)", the transmission interval of
JPEG images may sometimes become longer.
[Internet mode (over HTTP)]
Select "On" when transmitting H.264 images via the Internet. It is possible to transmit H.264 images without
changing the broadband router settings configured for JPEG image transmission.

On: H.264 images will be transmitted using the HTTP port. Refer to section 13.1 for further information
about the HTTP port number settings.

Off: H.264 images will be transmitted using the UDP port.

Default: Off
Note

When "On" is selected, only "Unicast port (AUTO)" will be available for "Transmission type".

When "On" is selected, it may take time to start displaying H.264 images.

When "On" is selected, H.264 images may not be displayed depending on the number of the concurrent
access user, etc.

When "On" is selected, only IPv4 access is available.
[Image capture size]
Select the image capture size from the following.
Picture (Camera) mode VGA [4:3]
Picture (Camera) mode VGA [16:9]
Picture (Camera) mode D1

Default: VGA
[Transmission priority]
Select a transmission priority for H.264 images from the following.

Constant bit rate: H.264 images will be transmitted with the bit rate selected for "Max bit rate
(per client) *".

Frame rate: H.264 images will be transmitted with the frame rate selected for "Frame rate*".

Best effort: In accordance with the network bandwidth, H.264 images will be transmitted with the bit
rate varying between the maximum and minimum bit rates that are set for "Max bit rate (per client)*".

Default: Frame rate
Note

When "Frame rate" is selected for "Transmission priority", number of users who can access the unit may
be limited more (may become less than 10).
[Frame rate*]
Select a frame rate for H.264 images from the following.
1fps/ 3fps/ 5fps */7.5fps */ 10fps */ 15fps */ 20fps */ 30fps *Default: 25fps *
Note

When "Frame rate" is selected for "Transmission priority", this setting is available.

"Frame rate*" is restricted by "Max bit rate (per client)*". For this reason, the frame rate may be lower than
the specified value when any value marked with an asterisk (*) is selected.
[Max bit rate (per client)*]
Select an H.264 bit rate per a client from the following. When "Best effort" is selected for "Transmission
priority", set the maximum and minimum bit rates.
64kbps/ 128kbps*/ 256kbps*/ 384kbps*/ 512kbps*/ 768kbps*/ 1024kbps*/ 1536kbps*/ 2048kbps*/ 3072kbps*/
4096kbps*/ Unlimited*

Default: 1536kbps*
8 Configure the settings related to images [Image]
QVGA/VGA
Not supported by the Thermal Camera
Not supported by the Thermal Camera
Operating Instructions 33