Configure The Settings Relating To H.264 Images [Jpeg/H.264] - Panasonic TC0938450-015CE Operating Instructions Manual

[Refresh interval (JPEG)*]
Select an interval to refresh the displayed JPEG image from the following.
0.08fps/ 0.17fps/ 0.28fps/ 0.42fps/ 1fps/ 2.1fps/ 3.1fps/ 4.2fps/ 5fps */ 8.3fps */ 12.5fps */ 25fps *
 Default: 4.2fps
Note

When "On" is selected for "H.264 transmission", the refresh interval may be longer than the set value when
any value with an asterisk (*) on the right is selected.

Depending on factors such as the network environment, the resolution, the image quality, or the number of
computers concurrently accessing the unit, the transmission interval may be longer than the set value.

If images are not delivered in the specified transmission interval, you can make the images be delivered
closer to the specified interval by lowering the resolution or image quality.
[Image capture size]
Select the image capture size to display the JPEG image on the "Live" page for the first time.
Picture (Camera) mode VGA [4:3]
Picture (Camera) mode VGA [16:9]
Picture (Camera) mode D1
 Default: VGA
[Image quality]
Select the image quality of JPEG images displayed initially on the "Live" page.
 Default: Quality1
[Image quality setting]
Select two types of image quality of JPEG images for each image capture size.
0 Super fine/ 1 Fine/ 2/ 3/ 4/ 5 Normal/ 6/ 7/ 8/ 9 Low

Default:
–
Quality1: 5 Normal
–
Quality2: 8
The setting for "Quality1" is activated for FTP periodic image transmission.
8.3 Configure the settings relating to H.264
images [JPEG/H.264]
Click the [JPEG/H.264] tab on the "Image" page. (section 6)
Configure the settings relating to H.264 image such as "Max bit rate (per client)", "Image capture size", "Image
quality", etc. in this section. Refer to section 8.2 for the settings relating to JPEG images.
8 Configure the settings related to images [Image]
QVGA/VGA
Not supported by the Thermal Camera
Not supported by the Thermal Camera
Operating Instructions 31