Action At An Alarm Occurrence; Alarm Type - Panasonic TC0938450-015CE Operating Instructions Manual

3 Action at an alarm occurrence

The alarm action (action at an alarm occurrence) will be performed when the following alarms occur.
3.1

Alarm type


VMD alarm: When motion is detected in the set VMD area, the alarm action will be performed.
*VMD stands for "Video Motion Detection".

Command alarm: When a Panasonic alarm protocol is received from the connected device via a network,
the alarm action will be performed.

Video loss alarm: The alarm will be activated when there is a loss of video input signals due to
disconnection of the thermal detector inside the Thermal Camera or camera problems.
3.2 Action at an alarm occurrence
Display the alarm occurrence indication button on the "Live" page
The alarm occurrence indication button will be displayed on the "Live" page at an alarm occurrence. (section
1.2)
IMPORTANT

When "Polling(30s)" is selected for "Alarm status update mode" (section 7.1), the Alarm occurrence
indication button will be refreshed in 30-second intervals. For this reason, it may take a maximum of30
seconds until the alarm occurrence indication button is displayed on the "Live" page at an alarm
occurrence.
Transmit an image onto a server automatically
An alarm image can be transmitted at an alarm occurrence to the server designated in advance. The settings
required to transmit an alarm image to a server can be configured in the "Alarm image" section on the
[Alarm] tab of the "Alarm" page (section 10.2) and the [FTP] tab of the "Server" page (section 12.2).
Notify of alarm occurrences by E-mail
Alarm E-mail (alarm occurrence notification) can be sent at an alarm occurrence to the E-mail addresses
registered in advance. Up to 4 addresses can be registered as recipients of the alarm E-mail. The settings for
alarm E-mail can be configured in the "E-mail notification" section on the [Notification] tab of the [Alarm] page
(section 10.4) and the [E-mail] tab of the "Server" page (section 12).
Notify of alarm occurrences to the designated IP addresses (Panasonic
alarm protocol notification)
This function is available only when a Panasonic device, such as the network disk recorder, is connected to the
system. When "On" is selected for "Panasonic alarm protocol notification", the connected Panasonic device will be
notified that the unit is in the alarm state. The settings for Panasonic alarm protocol can be configured in the
Panasonic alarm protocol section of the [Notification] tab of the [Alarm] page. (section 10.5)
3 Action at an alarm occurrence
Operating Instructions 17